Lenco 101 Standard Actuator 12V - 2-.25'' Stroke - Corrosion Proof Vandar Mounts

101 standard actuator. Included in standard trim tab kit, standard performance tab kit and bennett retrofit kit. 5/16'' inch (.79 centimeters) mounting hardware. Stroke: 2.25?¦ñ inches (5.72 centimeters). Length overall: 12-1/8'' inches (30.80 centimeters). Length pin to pin: 11.5'' inches (29.21 centimeters). Diameter (upper housing): 2.5'' inches (6.35 centimeters). Mounting hardware: 5/16'' inches ( .79 centimeters) or delrin pin (part #121). Part # (superseded #) #15054-001 (101-2), 12 volt with 6' feet (1.83 centimeters) cable with deutsch connector & mounting hardware (replacement length). Top cap gland seal sheaths the actuator cable outer jacket as well as both internal conductors for maximum waterproofing. Corrosion proof vandar mounts. Stainless steel ram won't flex, even under extreme loads. Double o-ring for maximum protection. Ball screw rotates freely on 12 ball bearings at both ends of its stroke so there's no need for complicated limit switches and clutches. Self-locking ball screw locks into position and will not drift. Precision molded, powdered metal, high alloy gears provide high accuracy, high wear resistance, and high strength for long life. Tough, high-torque motor easily transfers 750 pounds. High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced thermoplastic housing. Corrosion proof vandar cap and mount, stands up to severe loads. Manufacturer: lenco marine.